Simulation
Solar Power Regulator On Bread Board and Multisim
Objective:
1. To find
the output value from both of methods
2. To
distinguish between the both of circuit methods
3. To ensure
the project works
4. To learn
how that project work
5. To find
the potential problem
Procedure:
• STEP 1
1. Step one
is to construct the circuit by using bread board
2. Prepare
all the component that use in solar power regulator
3. Construct
the circuit following the schematic that prepare
4. Make sure
the terminal and polarity of each component is correct to connect
5. Battery 9
volt used in that circuit to replace solar panel
6. After
finish construct the circuit, double check the flow of circuit before running
7. The
circuit run and to check the output voltage use the multimeter
8. Multimeter
set on Dc voltage position.
9. Put the
probe to the output of circuit, and reading from the multimeter record.
• STEP 2
1. Step 2 is
to simulate the solar power by using Software Multisim 2001
2. Open the
software, and than create a new project
3. Select
all component that listed on schematic circuit
4. Construct
the circuit following the schematic of solar power
5. In this
multisim also used 9 volt battery
6. check the
output voltage by using multimeter or voltmeter in Dc.
7. Data
record from the output value.
Data record
1. On bread
Board = 2.44 volt
2. By using
Multisim = 2.087 V
Analysis:
From both value
there have a different output value of voltage. It is maybe that cause by
battery that use in bread board less than that required. It also the component
that use is not match from schematic. After battery disconnect we can see the
circuit still shown the output voltage.
From here we know that the capacitor 1 farad keep the
charge.
Conclusion :
To find the correct value of output voltage, we should
use the correct component.
Simulate by using Multisim
.png)
Multimeter Use to Measure output Voltage
.png)
Output Voltage is 2.44
No comments:
Post a Comment