Preparing To P.C.B Board Etching

Preparing To P.C.B Board Etching

Objectives:

1.         To prepare the circuit before

2.         To make the P.C.B layout

3.         To confirm that p.c.b solar layout

4.         To make sure that p.c.b layout correct before do the etching

Procedure:

1.         Here we have two choice. First, design the P.C.B by using software(Diptrace). Second, by using p.c.b layout from magazine.

2.         To facilitate the design process of making p.c.b circuit layout, there are examples in the magazine was edited according to the size needed  

3.         Original size and shape to the left magazine during edit on the p.c.b circuit sizes must follow to determine what was in the magazine. This is to prevent the components such as IC can not enter.

4.         Width of the circuit that edit or sketch is 38 mm. while the circuit is51mm long.

5.         After the editing process is made, the circuit print on the A4 paper. Double check circuit.

6.         If the circuit was not clear print, colour  the circuit to avoid the circuit is broken when the circuit is print on transparent

7.         After this process is complete then print paper had made photocopy to the transparent paper.

8.         If there have a problem on the transparent paper repeat the process for the second time.

conclusion:

            After all this process is made and has resulted in a complete p.c.b layout and all according to what is required then the next process can be done. The process is the process of etching the solar power circuit  

         Print from the magazine

P.C.B that print on transparent paper